Cookie Information

We use cookies to improve the website experience of our users. To learn more about our cookies, visit our Cookies Policy page.


Add Bookmark(s)



Bookmark(s) shared successfully!

Please provide at least one email address.

General Product FAQs

General Product(6)
Does thermal information change for IT parts?
Thermal information includes temperature limits and thermal impedance values. Temperature limits do change for IT parts (TC, TJ, and TA), but thermal impedance values (θJA, θJB, and θJC) do not because thermal impedance depends primarily on the package.
My design was based on a specification stating the JTAG was relative to VDD (1.8V), but now we’ve discovered that JTAG is actually relative to VDDQ (1.5V). It’s a fairly significant board spin to change this; what do I risk by leaving the design as-is? I assume that the specification is still for VDDQ + 0.3V = 1.8V, but with CMOS parts there’s no way I can guarantee that it won’t swing past that on transitions.
Your particular board design should not be a cause of major concern. The pins can handle the VDD voltage regardless of the VDDQ voltage.
Should the ECC memory chip share chip select and CKE signals with the other two main memory chips in our point-to-point application?
The ECC chip(s) should share the same CKE and CS# as the other devices because they are accessed as the same piece of data.
What is a "bank"?
A bank is an array of memory bits. Multiple arrays or banks are contained within a DRAM component. Depending on density, DRAM components may consist of 4 or 8 banks. For example, a bank may consist of 32 million rows, 4 bits across. This would equate to 128 megabits. Four of these banks in a single DRAM component would yield a 512Mb component.
What is the impedance tolerance of the driver in match-impedance mode relative to the expected value base on the perfect reference resistor connected to ZQ pin?
The impedance tolerance of the driver is ±15 percent.
Who do I contact if I have questions about my order?
If you have any questions about your order, contact